If there are two or more solid bodies in the part file click the solids selector to choose the participating solid body.
Autodesk inventor sheet metal flange.
Set a distance for the height of the flange or select to and select geometry to define.
To add a flange feature you select one or more edges and specify the size and position of the material added.
To add a flange feature you select one or more edge and specify a set of options that determine the size and position of the material added.
Learn more about the flange feature in this vi.
Notice in the first photo that the slotted hole is off center.
The edge select mode is active.
Flange features are added by selecting one or more edges and specifying a set of options that determine the size and.
Click an open profile.
The flange previews along the edge selected using the default parameters.
The sheet metal flange feature consists of a face and bend connected to an existing face along a straight age.
On the ribbon click sheet metal tab create panel flange.
Create a flange and define its width as an offset.
You can override the default sheet metal.
On the ribbon click sheet metal tab create panel contour flange.
You can also specify the width or offset of the new flange.
Create a contour flange.
A flange feature consists of a face and bend connected to an existing face along a straight edge.
Use the flange command to add a sheet metal face and a bend to an existing sheet metal face.
Sheet metal flange features consist of a face and bend connected to an existing face along a straight edge.
Upon measuring the slots are correct to the flange but the flange is not centered on the sheet.
Create a 2d open profile sketch.
Although the sheet metal face feature may be considered the most fundamental of sheet metal features sheet metal parts consisting of a single face are in the minority.
I added a flange a couple actually to a part and two of them did not center properly.
A flange feature consists of a face and bend connected to an existing face along a straight edge.
Project sheet metal flange to plane at that point i hadn t seen the image you posted so i didn t know where the reference plane was in relation to the flange.
I did not realize it until i used the part in an assembly.
Create sheet metal flange along edge on the ribbon click sheet metal tab create panel flange.
You can override the default sheet metal style settings using the unfold options and the bend or corner tabs on the feature creation dialog box.
You can specify the depth and the angle of the flange and whether it is created inside or outside the existing face.
When creating a flange of an offset width you select only a single edge.
